Skip to main content

Preparing a Cut File

← Back to Onefinity hub

Preparing a Cut File

Design at Home Checklist

  1. Confirm project units (inches vs mm) — must match your post-processor choice
  2. Set up the correct machine profile in VCarve (per the Onefinity + Vectric setup guide):
    1. VCarve → Machine → Machine Configuration Management
    2. Click Download from the Cloud (upper-right corner) → Yes
    3. Manufacturer: Onefinity
    4. Series: Elite Redline (correct for Gen 2 Redline/Realtime)
    5. Model: Foreman 48×48
    6. Configuration: Defaults (unless rotary added later)
    7. When saving toolpaths, choose: Onefinity Redline/Realtime (inch) or (mm) — match your project units

    Backup/manual post-processors: RealTime CNC

  3. Design your part and assign toolpaths — see Speeds and Feeds for starter values
  4. Run 3D preview / simulation in VCarve — check for unexpected plunges, tabs, and rapid collisions
  5. Save your .crv project and bring it to the shop via USB drive or cloud (either works)

At the Shop — Export Toolpaths

  1. Open your .crv file on a master VCarve computer (CNC PC or vinyl cutter PC)
  2. Re-check tooling and run 3D preview again
  3. Save toolpaths → export G-code with the correct post-processor
  4. Transfer G-code to the dedicated CNC PC running RTS-X (USB or cloud)

Once G-code is on the shop PC, continue to Running a Job for simulation, machine startup, and job execution.

← Speeds and Feeds   |   Next: Running a Job →

Back to top